3D-Print Enclosure

A 3D-print design is available to those who need an indoor enclosure:

Open

Open

The enclosure 3D print files are available from the Downloads page.

External parts

This enclosure was created for the MPCam RevB.

To mount the MCam, you will need:

• 2X screw M2.5x6mm with a pan head.

To close the Lid, you will need:

• 4X screw M2.5x10mm with a pan head.

This case is designed to attach to a tripod, assuming a “standard” mount with a 3/8" screw.

Print information

For good printing results, we recommend:

• Material: SLS Nylon PA12

• Maximum layer height: 0.28mm

• Minimum infill percent: 20%

• Minimum wall thickness: 1.2mm

• Print range: 35 to 45mm/s

• Print both parts in horizontal mode

• No supports needed

• No raft needed

Open